Remove the seal on the box. Take the protective cover inside the box and keep them aside. Take the printer from the box.
Remove all the tape from inside the printer. Lower the output tray, and ink cartridge access door to open it. Remove all the tape and packing materials inside the printer.
Close the ink cartridge access door. Check if all the materials from the box are kept aside before discarding it.
At this stage, do not use the USB cable to connect the printer and the computer. Plug it in during the driver 123.hp.com/setup 2135.
Connect the outlet end of the power cord to the rear of the printer and the other end to the electrical outlet. Push the power button to switchon the printer. The printer makes a noise and carriage moves.
Use the setup cartridge that comes in the shipment box. Try to use the original ink cartridge for the best print quality.
Raise the 123.hp.com/dj2135 printer input tray. Remove any paper present in the input tray. Slide the paper width guides to the left as far as possible.
Load the stack of paper into the input tray and push the stack into the tray until it stops.
Move the paper width guide to the right and push it until it rests at the edge of the paper. Lower the output tray and pull output tray extender. Install the driver on the computer.
After setting up the HP Printer. Print a test page to confirm the printer setup.
No comments:
Post a Comment